Degermann - Baranil - Luxury French Calfskin Leather (HIDES)

PRODUCT SPECS

• Article:  Baranil
• Tannery:  Degermann 🇫🇷 (France)
• Full Grain: Yes
• Tannage: Vegetable Re-Tanned
• Cut: Full Hide = Whole Hide, 1/2 Hide = Side
• Grain (Top): Smooth 
• Flesh (Bottom): Smooth Nap
• Firmness: Medium 7/10
• Dye: Completely Through 
• Finish: Semi Aniline 
• Burnishable: No, Edge Paint Recommended
• Thickness: 5oz (2.0mm) +/- 0.3mm
• Splitting: Yes, down to 0.6mm  *Please note split leather cannot be returned & if hide is wider than 27" we will need to cut it into 2 pieces to fit the splitter (We cut closer to the belly side)
• Restocked: Yes, every 3-4 months
• Yield: High 80%+, With a natural product like leather, there can be areas with neck and back wrinkles, veins, scars, bites, loose grain, but in general this article can expect an overall high cutting area. Sides do include bellies where there can be some loose grain. This leather being semi aniline (meaning the leather is very mostly natural with some slight finishing) the leather will have most areas of concern covered improving yield. Darker colors will also better hide any areas of concern. A key skill of using full aniline leather is the ability to work less desirable areas of the hide into the less visible areas of your projects. Overall this article has a high cutting yield
• Discounts: Yes, volume discounts automatically applied on full hides, you can mix and match colors. Note Paypal does not load the discounts, please pay with credit card instead
  

Please note the images are a representative of the actual product, however computer and device screens vary as do dye lots. The leather you receive may look different than it appears on your screen. We suggest that you request sample(s) before ordering when color is critical. Product descriptions are to the best of our knowledge, if you notice any errors please contact info@rmleathersupply.com

Leather splitting is a custom service available down to your preferred thickness

Please note split leather can't be returned

There is a tolerance to leather splitting. While we have invested a lot of time and training into hitting a tighter tolerance range than advertised, sometimes the  leather articles and differing densities require the full tolerance range. 

Leather tolerance is denoted by +/- which means the leather can be both above and below that number by the denoted amount.

• Example 1.2mm +/- 0.1mm.
• This means that the leather could come anywhere ranging from 1.1-1.3mm across the hide. Most the time this amount is indiscernible to the naked eye, but should be noted if measuring with precise equipment

How we gauge the leather is with a thickness gauge that can reach both the edges and middle of the hide. We apply a moderate amount of pressure (Not too hard and not too soft)

Again our tolerances are tighter than the tanneries. We are usually well inside the range, especially on panels, but occasionally need the full range. Tolerance ranges are as follows: 

Splitting Panels: +/- (0.1mm).

Splitting Full Hides & Half Hides:  +/- 0.15mm

No Splitting (From Tannery Splitter):  +/- 0.2mm

• The width of our splitter is 30 inches. If you have a hide that is larger we will trim the hide to fit and return you both pieces. We cut off the belly section leaving you the nicest area of the hide in tact.
• Due to it requiring often multiple passes we do not send the split flesh part.