Rocky Mtn - Super Natural - Natural Veg Tan Leather (HIDES)

PRODUCT SPECS

• Article:  Super Natural 
• Tannery: Europe
• Tannage: Vegetable Tanned
• Full Grain: Yes
• Finish: Full Aniline
• Firmness: Medium (6/10
• Cut: Double Shoulder (No Belly = Higher Yield)
• Grain (Top): Smooth
• Flesh (Bottom): Smooth
• Dyeable: Yes, accepts dye very well!
• Burnishable: Yes
• Stampable: Yes
• Wet Moldable: Yes
• Thickness: 2-10oz (0.8-4.0mm) +/- 0.2mm
• Restocked: Yes, every 3-4 months
• Yield: Grade 1/2 - High 80%+, Utility 60% good for dye and tooling With a natural product like leather, there can be areas with neck and back wrinkles, veins, scars, bites, loose grain, but in general this article can expect an overall high cutting area. Double Shoulders also increase the cutting yield due to having no bellies where most the defects and loose grain are located. If you require large cuts for bigger products like totes, duffles, etc., we recommend whenever possible ordering a full hide. This leather being full aniline (meaning the leather is very natural with no extra finishing on the surface to hide any flaws) A key skill of using full aniline leather is the ability to work less desirable areas of the hide into the less visible areas of your projects.
• Discounts: Yes, you can mix and match thickness of the full hides. Volume discounts automatically applied. Note Paypal does not load the discounts, please pay with credit card instead

Please note the images are a representative of the actual product, however computer and device screens vary as do dye lots. The leather you receive may look different than it appears on your screen. We suggest that you request sample(s) before ordering when color is critical. Product descriptions are to the best of our knowledge, if you notice any errors please contact info@rmleathersupply.com

Leather splitting is a custom service available down to your preferred thickness

Please note split leather can't be returned

There is a tolerance to leather splitting. While we have invested a lot of time and training into hitting a tighter tolerance range than advertised, sometimes the  leather articles and differing densities require the full tolerance range. 

Leather tolerance is denoted by +/- which means the leather can be both above and below that number by the denoted amount.

• Example 1.2mm +/- 0.1mm.
• This means that the leather could come anywhere ranging from 1.1-1.3mm across the hide. Most the time this amount is indiscernible to the naked eye, but should be noted if measuring with precise equipment

How we gauge the leather is with a thickness gauge that can reach both the edges and middle of the hide. We apply a moderate amount of pressure (Not too hard and not too soft)

Again our tolerances are tighter than the tanneries. We are usually well inside the range, especially on panels, but occasionally need the full range. Tolerance ranges are as follows: 

Splitting Panels: +/- (0.1mm).

Splitting Full Hides & Half Hides:  +/- 0.15mm

No Splitting (From Tannery Splitter):  +/- 0.2mm

• The width of our splitter is 27-28 inches. If you have a hide that is larger we will trim the hide to fit and return you both pieces. We cut off the belly section leaving you the nicest area of the hide in tact.
• Due to it requiring often multiple passes we do not send the split flesh part.